Understanding the workings of Vertical Deflection

Vertical deflection parts, serves to provide a sawtooth current to the vertical deflection coil so that horizontal lines are generated by applying localized horizontal deflection from the top of the screen and moves towards the bottom of the screen. Sweeping PAL system has a vertical frequency of 50 Hz and 60 Hz NTSC system. Vertical deflection circuit there are several variation, is in contrast to the horizontal deflection circuit on television almost all the same.
Broadly , the vertical deflection section comprises:
Yoke DEfleksi
Yoke Deflection
  • Vertical oscillator (vertical countdown)
  • Ramp generator
  • Vertical amplifier drive
  • Vertical amplifier-out
  • Pum-up (flyback generator)
  • Feedback circuit
  • Vertical deflection coil

Countdown vertical as the vertical oscillator. Vertical count-down got input from the horizontal frequency count-down and divide in order to obtain the vertical frequency.
In this section there is a circuit called a "vertical window-counter" which serves to automatically adjust the vertical size of the frequency. Without any input video signal, vertical oscillator oscillates at a frequency of approximately 45 to 55Hz free. If then the aircraft received the system PAL video signals, vertical-counter window will lock the vertical oscillator at a frequency of 50Hz. And if a video signal NTSC system will automatically lock the vertical frequency to 60Hz

If for any damage, so the frequency can not be locked, it will cause:
  • Picture rolling up if the frequency is lower
  • Rolling down the picture if the frequency is higher.

Ramp-generator - vertical pulses from the oscillator is a square, ramp-function generator to change the shape of the signal box into a sawtooth shape. Sawtooth signal shape is determined by the value of resistor-capacitor filter contained in this section.

Vertical count-down circuit and the ramp-generator circuit is in common IC. But there are certain circuits where the ramp generator IC is in the vertical-out, ie aircraft using the TA8690 and TA8445.


Vertical amplifier Drive - serves to amplify the signal before it is fed into the vertical vertical-output amplifier. Circuits generally be one with a vertical power amplifier out.


Vertical power-amplifier Out - vertical sawtooth signal is amplified by this section to be able to supply power to the coil current sawtooth vertical deflection. The working principle of the vertical amplifier-out does not vary much with the audio power-amplifier


Pump Up (flyback generator) - applying localized electron beam vertically from the top to the bottom of the screen. To conduct further re-sweeping the electron beam must be returned with a quick way into the top layer. To do this required a strong pulse but only a moment the so-called vertical-retrace pulse, which pulse is required to establish a higher voltage supply on the vertical-out amplifier.

While doing the sweeping-vertical from the top of the screen to the bottom of the screen vertically-out circuit generally requires a voltage supply of about 25V. And at the vertical-retrace or back from the bottom to the top of the screen quickly takes a larger supply voltage of about 50V. Vertical pump-up circuit is in the vertical IC-out and serves to generate a high voltage at the moment-vertical retrace and require external components consisting of a diode and an Elko.

Vertical-drive circuit, pump-up and reinforcing vertical-out is generally a single IC package in the vertical-out.

There are several types of vertical IC-outs that do not use a pump-up circuit. Instead of the vertical-out requires two kinds of supply Vcc, the supply of low voltage and high voltage supply.

Comments

Popular posts from this blog

TDA2030 complete tone control

1500W Stereo Power Amplifier Schematic