Power Amplifier

Toggle switch in this article is a series of toggle switches that are controlled by infrared light. The series toggle switch is made from a combination of data flip-flop CD4013 2 units. Receiver circuit of the infrared light signals arranged with infrared receiver as found on television remote receiver. Infrared signal from remote is used as clock signals and data to the data flip-flop first. then the second flip-flop data set as a toggle flip-flop toggle the output signal is used to drive the relay. for more details can be seen in thethe following image . Series Toggle Switch With Infra Red (IR) that is required to supply voltage range of 12VDC and the output of Toggle Switch With Infra Red (IR) is dapt used to turn on the lights or other electronic devices with DC or AC voltage source. Series Toggle Switch With Infra Red (IR) was isolated from the load that is placed for use as the final relay. source [ link ] 

This time, there is a series of audio amplifer 20W as well, but using IC TDA 2005 as a series of his base amplifier. The series of 2x20 Watt Audio Power Amplifier using TDA2005 can you see in the picture below. Technical Data: Performance of TDA2005M: (for this circuit); At 4.14 V supply voltage: 2 x 20 watts (stereo) into 4 Ohms. Distortion: Approx. 0.2% at 4 Watts into 4 ohm load. Frequency Range: Approx. 20 Hz to 22 KHz. Input Sensitivity: Approx. maximum 150 mV rms. . Power supply: + 8 to 18 volts, approx. 3.5 Amps maximum per channel. source [ link ] 

Here i share power amplifier based on IC TDA7236 . This amplifier require minimum voltage 0,9 volt and maximum voltage is 1, 6 volt , its very low voltage amplifier. You can use this amplifier everywhere just with one battery 1,5 volt. Power output 16 mW with 32 ohms impedance. see circut below :