TA7200P and TA7204P ,10 watt power amplifier

By -
TA7200P has a 3,3 W output and the equation of TA7204P has a power output of 4,2 W , using the circuit above , in  both ic can have 10 watts of output power amplfier , but the quality of each ic remains different. Both ic manufactered by TOSHIBA.


Part List :
Resistor   = 100K x 2, 820R
Capacitor = 1uF , 10uF , 100uF x 2, 4u7F , 820pF , 15 pF , 47uF, 470 uF.
IC            = TA7200P / TA7204P

Technical information :
Max. Voltage = 20 Volt DC
Min. Voltage = 10 Volt DC
Max. Output = 10 Watt
Approx. RL  = 4 - 8 Ohm
Approx. Ft   = 30Hz - 18KHz

Comments

Post a Comment

Popular posts from this blog

1500W Stereo Power Amplifier Schematic

By -
Image
Circuit Power Amplifier has a power output of up to 1500W RMS power amplifier circuit is often used to power sound systems keperlun for outdor. In the final image can be seen a series of power amplifiers using 10 sets of power transistors for the ending. This power amplifier circuit using a transistor amplifier from the front, signal splitter, driver and power amplifier. Current consumption required is quite large power amplifier that is 15-20 A 1500W power amplifier circuits for this. Supply voltage needed by the power of this amplifier is the optimal working order symmetrical 130VDC (130VDC-130VDC ground). 1500W amplifier circuit below is a picture series of mono, stereo if you want to make it necessary to make two copies of the circuit. For more details can be viewed directly image the following 1500W power amplifier circuit. The series of High Power Amplifier 1500W With Transistor Click Image to view larger In the above series of power amplifer 1500W is equipped ...
Read more

TDA2030 complete tone control

By -
Image
At this time I present a series of amplifiers that use IC TDA2030, but this series is equipped with a tone control. Tone controls include Bass, Treebel, and Volume. Power amplifier and tone control has been put together in a single PCB. As well as its power supply circuit was also used as one with the power amp, and tone control. Making it easier in the installation and will look neat. Schematics Layout PCB PCB design This amplifier is a mono amplifier type, can be modif for guitar amplifiers. If not coupled amplifier (mic preamp) then you must deactivated potensio treble and bass, why? because if not using a mic preamp and still maintain potensio treble and bass sound input (input) from the guitar will not or the maximum discharge is not tight on the speakers. So you must deactivated a way to decide which directly connected capacitor with the tone control circuit, and capacitor were connected directly to potensio volume and input jack.
Read more