300W Subwoofer Power Amplifier

By -
300W woofer subwoofer systemThis is an amplifier circuit that is formed from a transistor amplifier miraculous. This circuit is used in the speaker subwoofer with 300W maximum power on each side. To apply it, can be used in the room that is not too large, like the car. And the voltage needed between 25 to 42 Volt DC.

This is schematic of 300W subwoofer amplifier

subwoofer amplifier circuit rangkaian skematic

Comments

  1. UnknownJanuary 17, 2013 at 6:33:00 PM GMT+7

    WHO MANY WATT MUSH POWER SUPPLY BE..? RESISTORS ARE IN OHMS..? ΤΗΑΝΚ ΥΟU..

    ReplyDelete
  2. rajakumarAugust 11, 2015 at 3:43:00 PM GMT+7

    I think biasing missing at base of transistors near zenaar diode.Plz correct if so,and what is the use of variable 470 ohms resistor?

    ReplyDelete
  3. Simon AdamsDecember 19, 2017 at 1:52:00 PM GMT+7

    That is what info I am looking for, Thank you

    ReplyDelete
  4. UnknownAugust 18, 2018 at 8:03:00 AM GMT+7

    Cannot there be a power rectifier and tone controller circuit ?

    ReplyDelete

Post a Comment

Popular posts from this blog

1500W Stereo Power Amplifier Schematic

By -
Image
Circuit Power Amplifier has a power output of up to 1500W RMS power amplifier circuit is often used to power sound systems keperlun for outdor. In the final image can be seen a series of power amplifiers using 10 sets of power transistors for the ending. This power amplifier circuit using a transistor amplifier from the front, signal splitter, driver and power amplifier. Current consumption required is quite large power amplifier that is 15-20 A 1500W power amplifier circuits for this. Supply voltage needed by the power of this amplifier is the optimal working order symmetrical 130VDC (130VDC-130VDC ground). 1500W amplifier circuit below is a picture series of mono, stereo if you want to make it necessary to make two copies of the circuit. For more details can be viewed directly image the following 1500W power amplifier circuit. The series of High Power Amplifier 1500W With Transistor Click Image to view larger In the above series of power amplifer 1500W is equipped
Read more

TDA2030 complete tone control

By -
Image
At this time I present a series of amplifiers that use IC TDA2030, but this series is equipped with a tone control. Tone controls include Bass, Treebel, and Volume. Power amplifier and tone control has been put together in a single PCB. As well as its power supply circuit was also used as one with the power amp, and tone control. Making it easier in the installation and will look neat. Schematics Layout PCB PCB design This amplifier is a mono amplifier type, can be modif for guitar amplifiers. If not coupled amplifier (mic preamp) then you must deactivated potensio treble and bass, why? because if not using a mic preamp and still maintain potensio treble and bass sound input (input) from the guitar will not or the maximum discharge is not tight on the speakers. So you must deactivated a way to decide which directly connected capacitor with the tone control circuit, and capacitor were connected directly to potensio volume and input jack.
Read more