10W audio power amplifier with bass boost


As the amplifier circuit also uses a number of frequencies to drive the loudspeaker, the bass frequencies will be reduced. Therefore need to be plugged the bass-boost control at fedback loop amplifier, this is done to overcome the decline in quality.


Graph bass can reach a maximum at +16.4 dB @ 50Hz.
This circuit can be connected directly to the CD player, tuner, and tape recorders. Q3 and Q4 must be in pairs with a heatsink.

Adjust the volume control at minimum position and R3 with a minimum value of resistance as well. try enabling circuit R3 da set up to read the flow of about 20 to 25mA. Wait for 15 minutes, connect the ground at J1, P1, C2, C4 C3dan. Connect also C9 at the output ground.


For his series of power supply you can use the following scheme that fits perfectly with this amplifier.


Comments

  1. Nice blog. Would you please tell me which tools u used to design this circuit ?
    If you have enough time, please review my circuit 10W audio amplifier circuit
    which facts should i consider when i design ?

    ReplyDelete
  2. I would recommend the more expensive models for professionals or hi conclusion players. best bass amp

    ReplyDelete

Post a Comment

Popular posts from this blog

1500W Stereo Power Amplifier Schematic

TDA2030 complete tone control