Lightning Protection ELCB

By -
Lightning Protection ELCB (CIRCUIT BREAKER Earth Leakage)
Installation of a building usually equipped with a safety short circuit current and current limiters. In the event of a short-circuit the safety fuse will break, and when the series occurred over the current-limiting load (MCB) will open the circuit so that circuit current flow to the inside of the building to be disconnected.




If it occurs in an electrical installation safety is a leakage current and current-limiting fuses can not provide security so that the power loss will occur continuously. Apart from that, if there are power users have a leakage current and untouched by humans, the safety will not be decided so that the electrical circuit is quite dangerous it would be safe if the installation is already installed grounding.
But when man-voltage electrical power users then all these safety devices can not be secured. For that installed a safety device, called an Earth Leakage Circuit Breaker or ELCB. This tool is able to decide the relationship string of leakage current in the event of 30 MA in a time of 0.1 seconds. Leakage current is intended to be through electrical components in the normal state of no voltage or phase conductor directly touched by humans.

How it Works chain of ELCB
ELCB separate chain consists of a magnetic coil and switch. This switch can be manually controlled electric and magnetic fields. If the position of liaison ELCB switch is closed, then the source voltage will flow gets the load. Magnet coils which will open the circuit to work when there is an electric current flowing in the coil. Magnet coil circuit that will open, works when there is an electric current flowing in the coil. ELCB magnet coil also called z. Travo, which normally do not get the voltage. If there is leakage current is z. Travo will work to open the circuit by pulling the main chain of the switch should be set up in advance for reuse and so on.

Comments

Post a Comment

Popular posts from this blog

1500W Stereo Power Amplifier Schematic

By -
Image
Circuit Power Amplifier has a power output of up to 1500W RMS power amplifier circuit is often used to power sound systems keperlun for outdor. In the final image can be seen a series of power amplifiers using 10 sets of power transistors for the ending. This power amplifier circuit using a transistor amplifier from the front, signal splitter, driver and power amplifier. Current consumption required is quite large power amplifier that is 15-20 A 1500W power amplifier circuits for this. Supply voltage needed by the power of this amplifier is the optimal working order symmetrical 130VDC (130VDC-130VDC ground). 1500W amplifier circuit below is a picture series of mono, stereo if you want to make it necessary to make two copies of the circuit. For more details can be viewed directly image the following 1500W power amplifier circuit. The series of High Power Amplifier 1500W With Transistor Click Image to view larger In the above series of power amplifer 1500W is equipped
Read more

TDA2030 complete tone control

By -
Image
At this time I present a series of amplifiers that use IC TDA2030, but this series is equipped with a tone control. Tone controls include Bass, Treebel, and Volume. Power amplifier and tone control has been put together in a single PCB. As well as its power supply circuit was also used as one with the power amp, and tone control. Making it easier in the installation and will look neat. Schematics Layout PCB PCB design This amplifier is a mono amplifier type, can be modif for guitar amplifiers. If not coupled amplifier (mic preamp) then you must deactivated potensio treble and bass, why? because if not using a mic preamp and still maintain potensio treble and bass sound input (input) from the guitar will not or the maximum discharge is not tight on the speakers. So you must deactivated a way to decide which directly connected capacitor with the tone control circuit, and capacitor were connected directly to potensio volume and input jack.
Read more